Zeck Audio STAC Force180 Przewodnik Instalacji Pobierz pdf (Strona 15)

Rev. 1.00 12-02-13 15/41

- Brazil (Anatel 220-250-713)

Refer to the New configuration commands section to find out how to configure this feature.

11778 Call transfer issue fixed

SmartWare did not push back SIP calls to the network when the call was coming from SIP and

going to an analog port. This undesired behavior has been altered and calls are now properly

pushed back to the network to save resources on the SmartNode.

11780 CED-Tone Net Side Detection enhancement

The command ced net-side-detection has been enhanced to make the behavior in case of

CED-Tone detection configurable. CED-Tone detection is only active when the SmartNode is

the calling party.

When the CED-Tone net side detection is enabled the user can choose between one of the 3

behaviors described below:

 (default) — Switch from audio mode to voice-band-data mode without

executing a re-invitation of the session.

 re-negotiation — Issue a re-invite for T.38. This behavior is only valid when fax

preferred codec is T.38.

 fallback — Switch to bypass (a bypass coder must be configured). If the

bypass coder is different from the audio coder then a re-invite is

sent. This behavior is only valid when fax preferred codec is T.38.

Refer to the New Configuration Commands section for a detailed description of the ced net-

side-detection configuration.

11802 Trusted SIP hosts to improve security

SmartWare now has a new SIP feature called “Trusted SIP hosts” where users can define a list

of trusted IP addresses or FQDNs that they want to allow to connect to a specific SIP interface.

If a SIP interface has at least one trusted host configured no other remote peers than the ones

in this list will be allowed to connect to the SmartNode. Refer to the New configuration

commands section to find out how to configure this feature.

11803 HTTP download failure blocks the SmartNode

Whenever an HTTP download job fails on a SmartNode, it causes the SmartNode to halt or

block. In order to get the SmartNode up and running again, it must be restarted. The problem is

fixed and from now on any unsuccessful HTTP jobs on SmartNodes will terminate in a graceful

manner.

11804 T.38 Fax transmission killed by CNG tone

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Brak uwag

Zeck Audio STAC Force180 Przewodnik Instalacji Strona 15